Operation Manual

Sailplane Section
Mode Setting
Press the A key to activate mixing, then press the
ACT or
INH key ( F or G ) to activate or inhibit the
trim mix 1 (or 2) function. Now you will input the
desired presets for the elevator, ailerons, and speed flaps.
Setting the Elevator Preset Amount
Press the
B key and set the rate with the numeric
keys E to M. The initial preset value is set to 0%, but
may vary from -100 to +100%.
Entering the Aileron 1 Servo Preset Amount
Press the C key and set the rate with the numeric
keys E to M . The setting range may vary from -100 to
+100% and the initial value is 0%.
Aileron 2 Servo Preset Inputting
Press the D key and set the rate with the numeric
keys E to M , as before. If your linkages and horns are
identical, this setting should be the same as for Aileron 1.
Speed Flap 1 Preset
To get to the Flap preset inputting menu, press the
NXT Q key. Then press the C key and set the rate
with the numeric keys E to M. As with the ailerons, the
initial value is set to 0%, but may vary from -100 to
+100%.
Speed Flap 2 Preset
Press the D key and set the rate with the numeric
keys E to M, as before. If your linkages and horns are
identicalM, this setting should be the same as for Speed
Flap 1.
Delay Rate Setting
Press the
R key and set the rate with the numeric
keys F to
M. The initial delay is set to 0%, but may
vary from 0 to 100%. A 100% delay takes about five
seconds to complete changing.
ON/OFF Switch Setting
An ON/OFF switch is not defined initially. To define
one, display the switch setting screen by pressing the
SWT P key. Use the keys to choose the switch and ON
direction you want. For a description of the switch setting
method, see page 37.
We recommend using the three-position switch for
Trim Mix activation. The lower position is usually defined
to be the launch mode (use TM1), middle position is
normal, and the upper position is used for the speed
settings (use TM2).
If you use the three position switch, you will want to
activate Trim mix on the middle position also. This will
give the delay in switching both to and From the trim
mix.
Trim Volume Control and Direction Setting
You may adjust all the presets as a group, but a
volume control is not defined initially. Call the volume
setting screen by pressing the
VOL O key. The volume
setting method is described on page 37. The volume con-
trol adds or subtracts ± 25% from all the preset positions.
Sailplane Section, Page 146