Operation Manual

Sailplane Section
ELEVATOR TRIM (ETM)—2-S/5-S
The two Elevator Trim functions program an
elevator offset position which may be called by a
switch, for example to set the elevator position for
thermalling or cruising. The two offsets may be
set independently. Elevator trim 2 has priority.
To prevent a sudden trim change when the
elevator trim is switched, a delay time can be
entered. The amount of offset may be changed in
flight by moving a volume control.
Activation of command
In the Condition Menu, press the ETM key to get the
ELE TRIMS menu, as shown in the figure.
Mode Setting
The same procedure is used to program both Trim 1
and Trim 2 settings. To switch between the elevator trim
1 and 2 setting screens, press the NXT Q key.
Press the A key to activate mixing, then press the
ACT or INH key ( F or G ) to activate or inhibit the
elevator trim function.
Elevator Trim 1 Setting Screen
Mode Setting
Delay rate setting
Offset Rate Setting
Mode Selection Keys
To Next Screen
To On/Off Switch
Setting Menu
Volume Setting
Return To
Condition Menu
To Previous Screen
Return To
Condition Menu
Set Value, Including Volume Control
Sailplane Section, Page 143