Operation Manual

Sailplane Section
BRAKE FLAP-AILERON MIXING—5-S
This mixing is used to make the ailerons oper-
ate together as brake flaps. When the brake flaps
are deployed, the brake flaps and ailerons all
perform the brake flap operation simultaneously.
The mixing rates for up and down brake flap
movement can be set independently. You may also
set up a switch for switching this mixing on and
off during flight. If this mixing is activated with-
out defining an ON/OFF switch, mixing remains
on all the time.
Activation of Brake Flap-Aileron Mixing
In the Condition Menu, press the
BKF key to get the
BRAKE FLAP menu.
Press the B key to get the BKF TO
AIL menu shown below.
Mixing State
Mode setting -
Mixing
Rate
Setting
To On/Off Switch
Setting Menu
Return To Brake
Flap Mixing Menu
Mode Selection Keys
Brake Flap Control Current Position
Use the A key to activate mode setting, then press
the ACT or INH keys (F and G) to activate or
inhibit brake flap coupling.
Setting the Down Brake Flap Mixing Rate
Press the C key, and then set the down aileron
mixing rate with the numeric keys E to M . The initial
value is +50% and the setting range may vary from —100
to+100%.
Up Brake Flap Mixing Rate Setting
Press the
D key and set the up aileron mixing rate
with the numeric keys
E to M . The setting range may
vary from -100 to +100% and the initial value is +50%.
ON/OFF Switch Setting
On initial setting, an activation switch for brake flap-
aileron mixing is not set, meaning that once activated, it
is on all the time. If you would like to set a switch to turn
it on and off, display the switch setting screen by pressing
the
SWT P key, and use the keys to choose the switch
and ON direction you want. For a description of the
switch setting method, see page 37.
Sailplane Section, Page 134