Operation Manual

Airplane Section
AlLERON DIFFERENTIAL (ADF)
This function uses two separate aileron servos
to independently correct yaw tendencies during
rolls. It is possible to adjust each aileron's positive
and negative deflection angles. When this function
is activated, receiver outputs CH1 and CH7 are
used for the two aileron channels. This function
may not be used if Flaperon (FPN) is chosen. If
desired, the amount of down aileron deflection
may be trimmed in flight with a knob or trimmer.
Setting Up Aileron Differential
Activation of command
In the Condition Menu, press the ADF key to get the
AIL DIFF menu shown below. Use the A ( ) key to
activate mode setting, then press the
ACT or INH
keys ( F and G ) to activate or inhibit the aileron dif-
ferential function.
Mode setting
Aileron 1
Left Side rate
Aileron 2
Left Side rate
Aileron 1
Right Side Rate
Aileron 2
Right Side Rate
Trimming volume
Setting
Return to
Condition screen
Mode selection Values in ( ) are the mixing rate, including the trim volume.
Aileron 1 Travel Setting
You now set the amount of servo throw for Aileron 1.
Press the B key to activate travel setting for the Left
direction and set the throw with the numeric keys. The
number keys 0 through 100 input the value directly.
The + and - keys increase or decrease the value by 1.
The +/- key may be used to reverse the throw direc-
tion.
If you are not sure what you are changing, hold the
stick to one side and press different keys — if there is no
effect, move the aileron stick to the other side and con-
tinue. Your setting may vary from -120 to +120%, the
initial value is+100%.
Now set the travel for the Right throw on Aileron 1.
Press the Q key to activate travel setting for the Right
direction and set the throw with the numeric keys as
before.
Aileron 2 Travel Setting
The setting process given above is repeated for Aileron
2. Press the C key to activate travel setting for the Left
direction and set the throw with the numeric keys.
Finally, set the travel for the Right throw on Aileron
2. Press the P key to activate travel setting for the Right
direction and
set the throw with the numeric keys as
before.
Trim volume setting
You may set up the Aileron Differential function so
that its effect may be changed in flight by moving a trim
control. The trim control adjusts the volume within ±25%
of the set differential rate. This option is not activated at
initial setup.
Call the volume setting screen by pressing the VOL
O key, and select the desired control using the screen
menus (for a description of the volume setting method,
see page 37).
Use the END (N) key to leave this menu.
Airplane Section, Page 80