Operation Manual

Helicopter Section
GYRO SENSITIVITY (GYR)
This function switches the gyro sensitivity. The
mode depends on the gyro used. Usually, sensiti-
vity 1 or 2 is switched in the normal mode.
The Normal mode is used with gyros having
two-step switching. The sensitivity is pre-adjusted
at two values and is selected by means of this
function.
The Linear mode is used with gyros whose
sensitivity can be switched linearly. The sensitivity
can be lowered according to the rudder travel by
means of this function.
An EXP mixing curve may also be input. The
sensitivity remains constant (maximum sensitivity)
up to the point at which gyro sensitivity is sup-
pressed according to rudder operation. However,
the maximum and minimum sensitivities are set at
the gyro.
Linear Mode
Position 0%
Gyro Sensitivity
Position 100%
Gyro Sensitivity
100%
100%
Using the Gyro Sensitivity Menu
In the Condition Menu. press the GYR key to get the
GYRO SENSE menu shown below.
Mode setting
Sensitivity No.
Selection
Return to
condition menu
Mode setting
Rudder stick
position setting
EXP rate setting
Mode selection
Helicopter Section, Page 114