Operation Manual

Helicopter Section
RUDDER->THROTTLE (R->T)
This mixing adjusts the throttle setting to
account for the changes in power required when
rudder commands are made. The amount of mix-
ing can be set for each condition, and the left and
right rates may be set separately. Trim volumes
may also be set.
Setting Up Rudders-Throttle Mixing
In the Condition Menu, press the R->T key to get the
RUD TO THR menu shown below.
Mode setting
Left side rate
Setting
Right side rate
setting
Trim Volume
Setting
Return to
condition menu
Mode selection Set value, including volume adjustment
Activation of Rudder-Throttle Mixing command
Use the A key to activate mode setting, then press the
ACT or INH keys ( F and G) to activate or inhibit
the Rudder-Throttle function.
Left-Side Rate Adjustment
Press the C key and you may input the rate with the
numeric keys E to M . You may set anywhere in the
range from -50 to +50% (initially the rate is set to +25%,
but a rate between 0 and 20% is recommended). Use the
+/- key to change the sign if necessary.
Right-Side Rate Adjustment
Press the D key and you may input the rate with the
numeric keys E to M . You may set anywhere in the
range from -50 to +50% (initially the rate is set to +25%;
again a rate from 0-20% is recommended).
Trim Volume Selection and Operating Direction Setting
You may set a control to adjust the trim volume
during flight. Call the volume setting screen by pressing
VOL ( O ) key. For a description of the volume
adjusting method, see page 37. This volume may be adjusted
by the volume control.
Helicopter Section, Page 113