Operation Manual

Airplane Section

Flap Trim Authority Setting

In the Flaperon mode. Flap Trim moves both ailerons

upwards or downwards together. To input the Flap Trim

Authority, move to the next screen by pressing the

NXT

R key. Then press the

key and set the rate with the

numeric keys F to M. You may choose any value from

0% to 100% for the Flap Trim Authority. The initial

setting is 30%, but a smaller number is recommended.

Flap Trim Offset Setting

Flap trim offset sets the flap position from which

motion occurs. To input the flap trim offset amount

setting, press the B key, then set the flap trimmer to the

position to be set and press the

SET

F key. The offset

can be anywhere between ±(trim authority setting).

Checking Your Work

After you have set up everything, be sure the controls

move the correct directions. If they do not, use the +/-

to reverse the direction as needed.

Use the

END

( N) key to leave this menu, or hit PRE

to get to the previous menu.

Airplane Section, Page 90