Operation Manual

9
PUSH
Charging jack
Battery cover
Battery connector location
Trainer function
/DSC function connector
RF module
To remove, press the tabs together
and gently pull rearwards.
To install, line up the connector pins with
the socket in the rear of the module and
gently snap into position.
Ni-Cd battery pack
NOTE: If you need to remove or replace the transmitter battery, do not pull on its
wires to remove it. Instead, gently pull on the connector’s plastic housing where it
plugs in to the transmitter.
The factory default functions activated by the switches and knobs for a Mode 2
transmitter are shown below. Note that some of the functions will not operate until
activated in the mixing menus. In general, functions for a Mode 1 transmitter
reverse the E and G switches.
Switch / Knob HELI ACRO GLID
Switch A Elevator Dual Rate
↓
= PMIX-1, 2 on
Elevator Dual Rate Elevator Dual Rate
↓
= Butterfly on
Switch B Rudder Dual Rate Rudder Dual Rate Rudder Dual Rate
Switch C CH 7
↑
= ELE→FLP on
center/↓
= Idle-down
↓
= Airbrake on
↑
= ELE→FLP on
center/↓
= Idle-down
↓
= PMIX-5 on
Switch D Aileron Dual Rate Aileron Dual Rate Aileron Dual Rate
Switch E Idle-up
↓
= PMIX-5 on back = Speed
forward = Start (Launch)
Switch F Inverted/CH5
↓
= PMIX-1, -2, -3 on
↓
= PMIX-1, -2, -3 on
Switch G fwd = Throttle Hold Landing Gear GLID1FLP:Gear
Switch H Trainer Snap Roll/Trainer Trainer
CH6 knob Hovering Pitch Flap
(Flap trim if FLPRON on)
GLID1FLP: Flap
(Flap trim if FLPRON on)
GLID2FLP: Camber
(Flap trim if FLP-AI off)
CH7 knob Hovering Throttle Spoiler
(disabled if AI-DIF on)
Spoiler
(disabled if AI-DIF on)
CH8 knob CH8 CH8 CH8