User Manual

96
Common function
Function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
Transmission of model data is possible with T6K
WUDQVPLWWHUV'DWDWUDQVIHULVSHUIRUPHGE\WKHUDGLR7KH
0'/75$16IXQFWLRQZRUNVZLWKWKHFXUUHQWPRGHO
you are using in the transmitter. As for the receiving
transmitter, any data on the current model that is receiving
the information will be over-written.
*T6K does not carry out normal operation during data transfer.
"M TRANS"
M TRANS
Model transfer
(Common)
●
MDL-TRANS between two T6K radios should be performed within 2-meter range.
① In each T6K, the ＋ or − key is pressed and it is
made "TRANSFER" and "RECEIVE".
＋ −
or
● "TRANSFER"：T6K of data origin
"RECEIVE"：T6K which receives data
Selection range：TRANSFER, RECEIVE
② Select "Execute" with the Jog key.
③ Hold down the Jog key [ each T6K ].
（1 second )
）
● "Complete" is displayed and the mode
transfer is finished.
Model transfer
● If data is not being transmitted, the receiving transmitter re-
turns to normal operation 10 seconds after execution. At this
time, "Failure" (not transmitting) is displayed.
Always check servo direction prior to every
flight as an additional precaution to confirm
proper model date, hook ups, and radio
function.
NOTE:
0'/75$16 EHWZHHQ WZR 7. UDGLRV VKRXOG
be performed within a 2-meter range.
CAUTION
MODE：
TRANSFER（T6K of data
origin ）／
RECEIVE（T6K which receives
data）
Execution of transmission/
reception
T6K-1 T6K-2
Model Data
TRANSFER RECEIVE