User Manual

71
Common function
■ Calling the setting screen
① Use the Jog key to select the P.MIX
number you want to use.
② Call the setting screen by press-
ing the Jog key.
● P.MIX 1-3（normal type）
● P.MIX 4（curve type）
P.MIX Selection
（P.MIX 1-3）
to P.MIX 1-3
set up screen
to P.MIX 4
set up screen
（P.MIX1-3 set up screen）
Mixing rate adjustment
Offset
Master CH selection
Slave CH selection
Function activation
● When INH is selected, the
function cannot be used.
When ON or OFF is selected,
the function is activated. ON
and OFF changes are linked
to the switch.
Trim ON/OFF
Switch selection
Switch direction
● Select the item with the
Jog key.
（Master CH Current position）
■ Function activation
① Select the MIX item and select ON
or OFF by pressing the + key or ‒
key.
＋ −
or
● When you do not want to use
the function select INH.
■ Master/Slave channel selection
② Select the MASTR channel you want
to use by pressing the + key or ‒ key.
③ Select the Slave channel you want to
us by pressing the + key or ‒ key.
● A VR as well as channels 1 to 6, can be specified as the
master channel. In addition, when OFS was selected as the
master channel, slave servo operation is offset.
■ Mixing rate adjustment
＋ −
or
④ Select the RATE item and adjust the
mixing rate by pressing the + key or ‒
key for each direction of the stick, etc.
selected at the master channel.
Range：-100 to +100%
Default：0%
● When you want to return the set value
to the initial value, press the + key and ‒
key simultaneously.
（Changing the ON/OFF Switch）
■ ON/OFF Switch selection
① Select the "SW" item and then se-
lect the switch by pressing the +
key or ‒ key.
or
Selection range：SwA-SwD
THR
■ Switch ON direction setting
② Select the "POSI" item and select the switch
ON direction by pressing the + key or ‒
key.
● 2P SW：NULL（always ON）, UP, DOWN
● 3P SW：NULL（always ON）, UP, UP&DN, UP&CT, CENTR, CT&DN,
DOWN
● THR stick: Hold the stick at the ON/OFF point
and set the ON/OFF position by pressing the Jog
key for 1 second. (If the Jog key is pressed for 1
second when the position was set, it returns to
the NULL state.) The switch ON direction can also
be selected by pressing the + key or ‒ key.
P.MIX1-3
＋ −
or
＋ −
or
（1 second）
＋ −