User Manual

70
Common function
Function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
P.MIX 1-3 (normal type)
The following functions can be set for programmable mixing 1 to 3:
【Mixing Channel】
● Use this function by changing the channel because the master channel and slave channels initial setting is a
temporary combination.
● When OFS was selected as the master channel, the mixing rate setting applies to slave only. When a mixing
rate is set, slave servo operation is offset by that amount.
● A VR as well as a channel, can be selected as the master channel.
【Trim selection】
● Whether or not mixing includes master channel trim operation can be selected.
【Mixing reference point change】
● The master channel mixing reference point can be shifted.
【Switch selection】
● The programmable mixing ON/OFF switch can be selected. The switches that can be selected are switches A to
D and the throttle stick.
● The switch operating direction can be set. When a 2 position switch was selected, up /down can be set, and
when a 3 position switch was selected, up/up and down /up / and center/center/center and down /down can
be selected. When the throttle stick was selected, the ON/OFF position and operation direction can be set.
When "NULL" is selected, mixing is always ON.
P. MIX 4（curve type）
Programmable mix 4 allows setting of the mixing rate by 5 point curve.
OFS and VR use and trim selection by normal type master channel setting described above are
impossible, but switch selection is possible.
Mixing that can independently customize 4
functions can be used. Programmable mixing is
used to remove bad tendencies of the aircraft and
PDNHRSHUDWLRQSOHDVDQW,QDGGLWLRQWRPL[LQJ
between arbitrary channels, trim addition, offset,
and switch setting functions.
"P.MIX"
P.MIX
Program mixing
(Common)