User Manual

63
Common function
Function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
Setting precautions
If sub trim is too large, the servo operating range
may be exceeded at maximum control surface
angle and generate a dead band in which the servo
does not operate. First connect the linkage so that
the amount of sub trim used is held to a minimum.
"SUB TRM"
● Select the channel with the
Jog key.
● SUB trim rate of each channel.
SUB trim rate of the selected channel.
SUB TRM
Sub trim
(Common)
① Select the SUB trim you want to set from
channel item and set the rate by pressing
the + key or ‒ key.
＋ −
or
Range：
-120 to +120%
Default：0%
● When you want to re-
turn the set value to
the initial value, press
the + key and ‒ key
simultaneously.
Sub trim
＜ ChannelDisplay ＞
AIRPLANE (2AIL1FLP) HELICOPTER GLIDER (2AIL2FLP) MULTICOPTER
1: AI1（Aileron1） 1: AIL（Aileron） 1: AI1（Aileron1） 1: AIL（Aileron）
2: ELE（Elevator） 2: ELE（Elevator） 2: ELE（Elevator） 2: ELE（Elevator）
3: THR（Throttle） 3: THR（Throttle） 3: FL3（Flap3） 3: THR（Throttle）
4: RUD（Rudder） 4: RUD（Rudder） 4: RUD（Rudder） 4: RUD（Rudder）
5: FLP（Flap） 5: GYR（GYRO） 5: FL5（Flap5） 5: AUX
6: AI6（Aileron6） 6: PIT（Pitch） 6: AI6（Aileron6） 6: MOD（Mode）
7: AUX 7: AUX 7: AUX 7: AUX
8: AUX 8: AUX 8: AUX 8: AUX