User Manual

61
Common function
Function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
0∼
140%
0∼
140%
The End Point function adjusts the
left and right servo throws, generates
differential throws, and will correct
improper linkage settings.
ŏ7KHVHUYRWUDYHOFDQEHDGMXVWHG
LQGLYLGXDOO\DWWKHOHIWDQGULJKW
VLGHV
Servo throw
At 100% setting the servo throw of each channel is about 40°
for channels 1 to 4 and about 55° for channels 5-8.
However, the maximum servo travel for channels 5-8 is about
110%.
*When channels 5 to 6 were mixed by 2 AIL etc, the throw
becomes the same (about 40° ) as channels 1 to 4.
"E POINT"
● Select the channel with
the Jog key.
● The setting rate of each chan-
nel
（Left ／ Down）
rate display
（Right ／ Up）
rate display
E POINT
End point
(Common)
① A channel is chosen by Jog key.
Selection range：CH1-8
② Operate the stick or VR of the selected
channel fully to the left (down) or right (up)
and adjust the rate by pressing the + key or
‒ key.
or
Range：
0-140%
Default：100%
● When you want to re-
turn the set value to
the initial value, press
the + key and ‒ key
simultaneously.
Adjust the rate of each direction of the stick and VR by repeating step ① .
End point
＜ ChannelDisplay ＞
＋
−
AIRPLANE (2AIL1FLP) HELICOPTER GLIDER (2AIL2FLP) MULTICOPTER
1: AI1（Aileron1） 1: AIL（Aileron） 1: AI1（Aileron1） 1: AIL（Aileron）
2: ELE（Elevator） 2: ELE（Elevator） 2: ELE（Elevator） 2: ELE（Elevator）
3: THR（Throttle） 3: THR（Throttle） 3: FL3（Flap3） 3: THR（Throttle）
4: RUD（Rudder） 4: RUD（Rudder） 4: RUD（Rudder） 4: RUD（Rudder）
5: FLP（Flap） 5: GYR（GYRO） 5: FL5（Flap5） 5: AUX
6: AI6（Aileron6） 6: PIT（Pitch） 6: AI6（Aileron6） 6: MOD（Mode）
7: AUX 7: AUX 7: AUX 7: AUX
8: AUX 8: AUX 8: AUX 8: AUX
Select the Left/Right (Down/Up)
with the stick (SW,VR).