User Manual

59
Common function
Function
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
WARNING
For safety, always set the fail safe functions.
Ɣ5HPHPEHUWRVHWWKHWKURWWOHFKDQQHOIDLOVDIHIXQFWLRQVRWKDW
the servo moves to the maximum slow side for airplanes and
to the slow side from the hovering position for helicopters.
Crashing of the model at full high when normal radio
waves cannot be received due to interference, etc., is very
dangerous.
Ɣ,IWKHEDWWHU\IDLOVDIHLVUHVHWE\WKHWKURWWOHVWLFNLWPD\
be mistaken for an engine malfunction and will be reset at
WKURWWOHVORZDQGWKHPRGHOZLOOFRQWLQXHWRÀ\,I\RXKDYH
any doubts, immediately land.
When normal radiowaves cannot be received due
WRQRLVHDQGLQWHUIHUHQFHWKH125PRGHZKLFK
holds the servo of each channel in its position
immediately before reception was lost, or F/S (Fail
Safe) mode, which moves the servo of each channel
to a preset position, can be selected. When T-FHSS
Air is selected, the battery fail safe voltage can be
set.
ŏ:KHQWKHWKURWWOHFKDQQHOZDVUHYHUVHGE\VHUYR
UHYHUVHIXQFWLRQWKH)6GDWDLVDOVRUHYHUVHG
ŏ,IWKHUHFHLYHUEDWWHU\YROWDJHGURSVEHORZWKH
VHWYDOXHZKHQWKHIDLOVDIHPRGHZDVVHOHFWHG
WKHEDWWHU\IDLOVDIHIXQFWLRQPRYHVWKHVHUYRWRD
SUHVHWSRVLWLRQ
ŏ7KH6)+66IDLOVDIHYROWDJHLV9
ŏ:KHQWKLVIXQFWLRQZDVSHUIRUPHGUHVHWWKHEDWWHU\
IDLOVDIHIXQFWLRQE\WKHIROORZLQJPHWKRGDQG
LPPHGLDWHO\ODQG
Reset method：
The battery fail safe function can be
temporarily disabled by moving the throttle stick to the slowest
side. However, after 30 seconds the battery fail safe function will
return to the battery fail safe state.
"F/S"
F/S
Fail safe
(Common)
■ Mode selection
① Select the mode by
pressing the + key or
‒ key at the MODE
item of each channel.
＋ −
or
（Range）
NOR, F/S
（When F/S mode was selected）
■ F/S position
② In the mode selected state, set the F/
S position by holding the stick of that
channel in the position you want to set
and press the Jog key for 1 second.
● A confirmation beeping sounds to
show that the servo position was
set.
■ When using the B-F/S mode
① Select ACT by pressing the + key or
‒ key at the B-F/S item.
＋ −
or
（Range ／ Default）
INH, ACT ／ INH
Fail safe
F/S Position
Mode select
● Select the setting item
with the Jog key.
Battery-F/S : ON/OFF