User Manual

53
Common function
① Select the SELE item and then se-
lect the model number by pressing
the + key or ‒ key.
＋ −
or
Selection range：1-30
② Press the Jog key for 1 sec-
ond.
（1 second）
● Confirmation message
"sure?" blinks.
③ Select the model by pressing the
Jog key.
● A confirmation "beep"
sounds to show that
selection is complete.
For safety, a double setting system is used. When a change is cancelled after the confirmation message is
displayed, the change is not made when moved to another setting item by Jog key.
Model select
① Select the LINK item and then press the Jog
key for 1 second.
（1 second）
● T-FHSS Air only. S-FHSS does not enter the link
mode. Use the receiver link button to link the
receiver.
② Enters the link mode for about 20 seconds. Dur-
ing this time, bring the receiver near the trans-
mitter and turn on the receiver power. When
linking, the receiver ID is displayed.
● In the link mode, a confirmation "beep"
sounds and the time remaining is
displayed on the screen. When 20 seconds
have elapsed, a continuous beep sounds
and the link mode is exited.
For safety, linking must not be performed while the drive motor or engine is running. When linking is
complete, turn the power off and on and check operation.
Link
① Select the RX item and then select
T-FHSS Air or S-FHSS by pressing
the + key or ‒ key.
＋ −
or
Selection range：
T-FHSS Air, S-FHSS
● Confirmation message
"sure?" blinks.
② RX type change by pressing the
Jog key.
● A confirmation "beep"
sounds is complete.
For safety, a double setting system is used. When a change is cancelled after the confirmation message is
displayed, the change is not made when moved to another setting item by Jog key.
RX type
*Link is required when a new model is made from a model selection.