User Manual

Before use
19
When Using The Optional Battery HT5F1800B
NiMH battery HT5F1800B
(not included)
Refer to the previous descrip-
tion and remove the trans-
mitter battery cover.
After removing the dry cell
battery box from the trans-
mitter, disconnect the con-
nector.
Insert the connector of the new
battery and load the new bat-
tery into the transmitter.
Connect the battery
connector.
Finish by installing the
battery cover.
Disconnect the
connector
Dry cell
battery BOX
Charging jack
CAUTION
When closing the battery
cover, be careful that the
battery cover does not pinch
the battery lead wires.
Shorting of the battery lead wires may
lead to fire and abnormal heating and
cause burns or fire disaster.
:KHQXVLQJDQRSWLRQDOUHFKDUJHDEOHEDWWHU\UHSODFHWKHEDWWHU\DVGHVFULEHGEHORZ
-Always use the optional HT5F1800B rechargeable battery.
-The type of power source used must be set by system setting.
:KHQWKHWUDQVPLWWHUZLOOQRWEHXVHGIRUDORQJWLPHUHPRYHWKHEDWWHU\
Charging a NiMH Battery
(Example: When using the HT5F1800B with the special charger)
1
Plug the transmitter cord of the special charger into
the charging jack on the rear of the transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
When Charging the Optional Battery HT5F1800B