User Manual

146
Glider
Function
Method
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
② Select
from the menu with the
Jog key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
1AIL 2AIL1AIL1FLP 2AIL1FLP 2AIL2FLPWING TYPE
● OFF-position
(0% : OFF)
● ON-position
(100% : High)
This function sets the operating motor when the
EP glider with motor is started by switch. The oper-
ating speed can individually set in 2 ranges of high
from slow and slow from high. If you do motor
control with a throttle stick, you should set this
function to INH.
ŏ)RUVDIHW\WKH212))VZLWFKRIWKHDLUFUDIWLWVHOI
FDQEHVHW
ŏ,IDWUDQVPLWWHUSRZHUVXSSO\LVVZLWFKHGRQZKLOH
WKHPRWRU6:KDVEHHQ21WKHZDUQLQJZLOO
RSHUDWH%HVXUHWRVZLWFKRQDSRZHUVXSSO\ZLWK
WKHPRWRUVWDUWVZLWFK2))
"MOT SW"
MOT SW
Motor switch
(GLIDER)
■ Activating the function
＋ −
or
① Select the "MODE" item
and then select the
"OFF" by pressing the
+ key or ‒ key.
● When you do not use a function, set to the
"INH" side.
■ Switch selection
＋ −
or
② Change the switch by
pressing the + key or
‒ key at the switch se-
lection item.
Range：SwA-SwD
■ Switch direction
＋ −
or
③ Select the
"DOWN" item
and then select
the position by
pressing the + key or ‒ key.
● 2P SW： UP, DOWN
● 3P SW： UP, UP&D, UP&C, CNTR,
C&DN, DOWN
■ Speed setting
④ Select "SPEED " next to (OFF) and (ON) by Jog key.
Range：OFF, 1-10 (more slowly)
●
(ON)
is the acceleration speed setting.
●
(OFF)
is the deceleration speed setting.
Motor
● Start SW
● Accelerating speed setting
● Decelerating speed setting
● If this safety switch
is not ON, the mo-
tor will not start
even if the starter
switch is turned on.
In "NULL", a safe
function does not
work.
● Present motor con-
trol position
DANGER
Always remove the propeller from the motor during setting and at operation checks.
Ŷ7KHUHLVWKHGDQJHURIWKHSURSHOOHUVSLQQLQJXQH[SHFWHGO\DQGFDXVLQJDVHULRXVLQMXU\