User Manual

128
Helicopter
Function
Method
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
② Select
from the menu with the
Jog key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
This mixing adjusts the gyro sensitivity from the
transmitter. The AVCS gyro (AVC mode) or normal
gyro (NOR mode) can be selected.
ŏ7KHJDLQFDQEHOLQNHGWRWKHFRQGLWLRQ&RQGRU
DQDUELWUDU\VZLWFKDQGVHW
ŏ:KHQWKH*<PRGHZDVVHOHFWHG$9&RU125
LVGLVSOD\HGDWWKHJDLQVHWWLQJYDOXH
ŏ7KHVHQVLWLYLW\VHWWLQJFKDQQHOFDQEHVHOHFWHG
ŏ7.RQO\FKDQQHOJDLQFRQWURO
ŏD[HVJ\URRIJDLQFDQWEHFRQWUROOHG
LQGHSHQGHQWO\
"GYRO"
GYRO
Gyro sensor
(HELICOPTER)
■ Activating the function
＋ −
or
① Select the "MIX" item
and then select the
"ON" by pressing the +
key or ‒ key.
● When you do not use a function, set to the
"INH" side.
■ Gain switch selection
＋ −
or
② Select the "SW" item
and then select the
switch by pressing the
+ key or ‒ key.
Range：Cond, SwA-SwD
Gyro setup
Activating the function
Condition
● When not using this function,
select INH.
Gain switch selection
（Present switch position）
● Switches to the gain setting
screen of each condition
when the Jog key is pressed.
● Select the setting item
with the Jog key.
（Gyro type） （Gyro Gain set）
●When a Futaba GY gyro is used, gyro type "GY" is selected. This switches the gyro gain setting
item to the mode and gain direct reading display.
AVC 100% NOR 100%
0%
AVCS Normal
＋
−
When a ＋ key is
pressed, gain of the
AVCS side is UP.
When a − key is
pressed, gain of the
Normal side is UP.
GAIN=OFF
■ Gyro mode and gain setting
③ When choosing Cond. → Set a mode and gain every each condition.
When choosing Switch → UP, CNT, DWN, shows the switch position. Set the respective position-
al gain and mode.