User Manual

122
Helicopter
Function
Method
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
② Select
from the menu with the
Jog key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
THR CUT
Throttle cut
(HELICOPTER)
■ Mode
① Select the "MODE" item and then select the
mode by pressing the + key or ‒ key.
＋ −
or
Range：NOR, ESC
Default：NOR
● "NOR"：Engine model
"ESC"：Electric motor model
■ Activating the function
② Select the "MIX" item and then select the off
by pressing the + key or ‒ key.
＋ −
or
● When you do not use a function, set to the
"INH" side.
Throttle Cut
This function cuts (stops) the engine or motor
by stick operation. At throttle operation, the rate is
adjusted to the position which completely cuts the
throttle servo or ESC when the throttle is operated.
When THR CUT is active, the throttle position is
held regardless of the throttle stick position.
ŏ7KHWKURWWOHSRVLWLRQZKHQWKHIXQFWLRQLVUHVHW
FDQEHVHWVRWKHPRWRUZLOOQRWXQH[SHFWHGO\
UXQDWKLJKVSHHGZKHQWKHWKURWWOHFXWIXQFWLRQ
LVUHVHW:KHQWKHWKURWWOHVWLFNLVKLJKHUWKDQWKH
VHWWKURWWOHSRVLWLRQWKHWKURWWOHFXWIXQFWLRQLVQRW
UHVHWHYHQLIWKHVZLWFKLVVHWWR2))6HWWRDVDIH
WKURWWOHSRVLWLRQVORZVLGH
125(6&PRGHWKHQH[WSDJHUHIHUULQJ
ŏ)XQFWLRQRSHUDWLRQFDQEHVHOHFWHGIURPDPRQJ
VZLWFKHV$
-
'
ŏ6HWWKHWKURWWOHFXWIXQFWLRQIRUVDIHW\DOVR
"THR CUT"
Mode
Cut Position rate
Throttle Position
Switch selection
● When not using this Function
select INH. The display of On/
Off is shown when active and
assigned to a switch.
● Adjusts the rate to the position
that completely cuts the
throttle servo or ESC.
● The value in parentheses is the
current throttle stick position.
● Select t
he
setting item with
the
Jog key
.
● Sets the ON/OFF direction of the selected switch.
○ 2P SW：NULL, UP, DOWN
○ 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN, DOWN
Activating the function