User Manual
Introduction
12
Do not use the nickel-hydride battery with de-
vices other than the corresponding transmitter.
Do not place heavy objects on top of the bat-
tery or charger. Also, do not place the battery or
charger in any location where it fall.
■ Doing so may cause damage or injury.
Do not store or use the battery and charger
where it is dusty or humid.
■ Insert the power cord plug into the receptacle only
after eliminating the dust.
After the transmitter has been used for a long
time, the battery may become hot. Immediately
remove from the transmitter.
■ Not doing so may cause a burn.
CAUTION
Do not charge the battery in extreme tempera-
tures.
■ Doing so will degrade the battery performance. An
ambient temperature of 10℃ to 30℃ (50 ℉ to 86 ℉ ) is
ideal for charging.
Unplug the charger when not in use.
Do not bend or pull the cord unreasonably and
do not place heavy objects on the cord.
■ The power cord may be damaged and cause
combustion, generation of heat, or electric shock.
Do not directly expose plastic parts to fuel, oil,
exhaust gas, etc.
■ If left in such an environment, the plastic may be
attacked and damaged.
■ Since the metal parts of the case may corrode, always
keep them clean.
Join the Academy of Model Aeronautics.
■ The Academy of Model Aeronautics (AMA) provides
guidelines and liability protection should the need arise.
Always use genuine Futaba products such as
transmitter, receiver, servo, FET amplifier, bat-
tery, etc.
Other Precautions
CAUTION
Keep wireless equipment, batteries, aircraft,
etc. away from children.
Storage and Disposal Precautions
WARNING
Do not store wireless devices in the following
places:
・ Where it is extremely hot (40℃ [104F] or higher)
or cold (-10℃ [14F] or lower)
・ Where the equipment will be exposed to direct
sunlight
・ Where the humidity is high
・ Where vibration is prevalent
・ Where it is very dusty
・ Where the device may be exposed to steam and
heat
CAUTION
When the device will not be used for a long
time, remove the battery from the transmitter
and aircraft and store them in a dry place where
the temperature is between 0 and 30℃ [32F and
86F].
■ Left standing 'as is' may will cause battery deterioration,
liquid leakage, etc.
■ Futaba is not responsible for damage sustained by
combination with other than Futaba Genuine Parts. Use
the parts specified in the instruction manual and catalog.