User Manual

115
Airplane
■ Activating the function
①
Select the "MIX" item and then select
the "ON" or "OFF" by pressing the +
key or ‒ key.
＋ −
or
● When you do not use a function, set
to the "INH" side.
■ Rate set
＋ −
or
②
Select the "rate" item and
adjust the servo travel by
pressing the + key or ‒ key.
Range：-100 to +100%
Default：+50%（ELEV only -10%）
● When you want to return the set value to the initial
value, press the + key and ‒ key simultaneously.
However, polarity does not return.
■ Delay Rate set
＋ −
or
③ Select the "delay" item and adjust the elevator
operation delay by pressing the + key or ‒ key.
● The amount of delay is large at 100%.
Range：0-100% Default：0%
● When you want to return the set value to the initial value, press the + key
and ‒ key simultaneously.
（In the case of change of a switch）
■ Switch selection
＋ −
or
① Select the "SW"
item and then
select the switch
by pressing the
+ key or ‒ key.
Range：SwA-SwD
Default：SwD
■ Switch direction
＋ −
or
② Select the ON direction by
pressing the + key or ‒ key at
the ON direction selection item.
Range：
● 2P SW：NULL, UP, DOWN
● 3P SW：NULL, UP, UP&DN, UP&CT, CENTR, CT&DN,
DOWN
（In the case of change of a mode）
■ Mode
＋ −
or
①
Select the
"MOD" item
and select the
operation mode
by pressing the + key or the ‒ key.
Range：OFST, LINR
Default：OFST
■ Operation reference point setting ("LINR" mode
only)
② Select the operation reference point setting
item newly displayed at the bottom row
of "MOD" and hold the throttle stick at the
air brake start point and set the reference point by
pressing the Jog key for 1 second.
Range：0-100%
（When 3CH control is changed at the time of "LINR"）
■ "LINR" mode 3CH control
① Select the "CH3" item and select control by pressing the +key or ‒
key.
Range：THR, SwA-SwD, VR
Default：THR
Air brake