FUTABA 4/5CHANNEL-DIGITAL PROPORTIONAL MANNUAL
* Modern, Light weight, easy to hold transmitter * T r a n s m i t t e r case designed so that control sticks are in a convenient operating position. * Antenna is angled for more effective radiation pattern. * B u i l t - i n transformer type battery charger. * Control stick knobs supplied in two length. * Maximum transformer output for positive control. * Receiver has automatic gain control (AGC) circuit for maximum noise suppression. * Compact, light weight receiver and servos.
SPECIFICATION FOR FUTABA 4/5 CHANNEL DIGITAL •TRANSMITTER: T4 PROPORTIONAL or RADIOS T5 Size: 71/7" x 6" x 23/4" (exclusive of antenna) Weight: 31bs including batteries Voltage: 9.6 volt DC Pulse width: 1.5 ms neutral varied 1ms for full control. •RECEIVER: Size: 2.340" x 0.835" x 1.580" Weight: 1.5 oz. Voltage: 4.8 volts DC •SERVOS: S2 Size: 2.250" x 1.50 x 0.830" Weight: 1.84 oz. Voltage: 4.8 volt DC Travel time: 0.6 second end to end.
BATTERIES: Before initial hook-up and operational check, transmitter and receiver batteries should be charged for 24 hours. BATTERY PACK "ON" FOR CHARGING CHARGING INSTRUCTIONS: Your transmitter contains a built-in transformer type nickel cadmium battery charger. A dual charging cord is packed with your radio control system. If you w i l l examine, the charging cord, you w i l l note that it is fitted with a standard 110 volt 2 prong line cord plug, a seven pin male and a four pin female connector.
TRANSMITTER: LOCATED ON FRONT PANEL: Two control sticks-4 trim levers-one lever for auxiliary (5th) channel operation-output meter. TOP PANEL: On-off switch-Antenna mount-Charging light indicator. BOTTOM PANEL: Two thumb screws. Removing these screws allowsacess to battery compartment, SIDE PANNE L: Left side contains battery charging connectors. THE CONTROLS PROVIDE THE FOLLOWING FUNCTIONS: The left hand control stick operate throttle and aileron.
vers. The auxiliary or 5 channel is not independently trimmable. Two sets of control stick knob of different lengths are supplied with this system, since individual preferences for control stick length may vary. Stick knob may be interchanged by merely pulling the knob directly away from the stick. The replacement knob should be pushed onto the stick until it is fixed.
The receiver should be loosely mounted in foam rubber or foam plastic to protect against vibration and shock. Battery pack should also be protected from vibration by wrapping in foam rubber. The receiver should also be protected from fuel by wrapping it in a plastic bag. The receiver antenna must be kept as far as possible from other wiring and metal parts. Excessive electrical noise is generated by metal to metal connections and may seriously interfere with receiver reception.
REPAIR SERVICE To insure prompt service, please follow the instructions listed below. The gears for repairing should be sent back to the distributor or local dealer. 1. Charge batteries for at least 18 hours prior to the despatch. 2. Return only the system, separate from your installation. Remove servos from mounts, remove foam padding from receiver. 3. Plugs or other modifications w h i c h interfer w i t h factory testing procedures w i l l be returned to factory standards at your expense. 4.
your dealer
