User Manual

•CHANGING THE THROTTLE STICK FROM A SELF-NEUTRAL SYSTEM TO A RATCHET SYSTEM
•When changing the throttle stick from a self-neutral
system to a ratchet system, install the optional slider.
Then, remove the spring and swing arm.
Install the optional
slider.
Twist with long-nose
pliers.
Remove the
spring and
swing arm.
•CRYSTAL REPLACEMENT
• When changing the band, remove the crystal holder and
change the crystal. (Except 72.75 MHz in USA)
•Futaba Digital Proportional Frequencies (FOR
U.S.A.)
•The frequency of Futaba digital proportional sets can be
changed within their own band. There are 4 different
bands for you to choose from (27 MHz, 50—53 MHz,
72 MHz, and 75 MHz.) Please see chart listed below for
specific frequency and its intended use. Please note there
are specific frequencies allocated for aircraft only and
surface only use.
•The frequency can be changed within the same BAND by
using a precisely matched pair of Futaba crystals.
However, Futaba recommends that you return your
system to our factory service department for frequency
changing, as turning may be necessary for proper opera-
tion. Changing frequency from one band to another is
NOT possible.
•Always change frequency flag when frequency is changed.
The frequency flag is to be attached to the top of antenna
and the channel designation to the base. (See Drawing)
• It is illegal to change crystals of 72—75 MHz bands in the
U.S.A.
4