User Manual

•LOADING THE PENLIGHT BATTERIES
• Remove the battery cover at the rear and insert eight penlight batteries in the correct polarity.
Rear cover mounting screws
Servo reverse
switches
(FP-T2NCR)
Slide in the direction of the
arrow while pushing here.
The batteries can be easily
loaded by inserting them
four at a time from the back.
• Extend the antenna fully and set the power switch to ON.
The level meter pointer should deflect to the silver zone. If the point-
er does not move, or moves very little, check for poor battery con-
tact, incorrect battery polarity, or faulty batteries.
• If the pointer of the level meter deflects to the red zone, the range of
the radio waves will become short. When the pointer drops to the
boundary between the silver and red zones, change the batteries.
•The trim levers are used to fine adjust the steering angle. They are
used to adjust the neutral position and for correcting the running
posture after the mechanism is mounted. After test running, make
corrections with the rod adjuster, etc. and operate the set with the
trim levers in the neutral position as much as possible.
•SERVO REVERSE SWITCHES
(FP-2NCR)
•This switch makes servo rotation to another-
direction.
• After fixed servos onto your model, and found
that rotation is wrong-way, switch to another
direction.
•Servo reverse switches are located at bottom of
Transmitter case like drawing below:
•STEERING TRIM LEVER ADJUSTMENT
Steering servo
reverse
switch
Normal Reverse
Normal Reverse
Throttle
servo reverse
switch
• When vehicle was run straight-
When vehicle turns
to the right
Move the trim lever slowly
to the left so that the ve-
hicle runs straight.
When vehicle turns
to the left
Move the trim lever slowly
to the right so that the
vehicle runs straight.
When vehicle was run straight.
*Adjust the trim lever so that the vehicle runs straight on a smooth road.
The throttle trim lever is used to fine adjust the speed controller stop position, etc.
3