User Manual

ManualsBrandsFutaba ManualsAccessories communication2NCS

Futaba

DIGITAL PROPORTIONAL

RADIO CONTROL

D60656

ATTACK-SPORT

SYSTEM

FP-2NCS/2NCR

•The

ATTACK-SPORT

high

performance

channel

digital

proportional

R/C

set

based

on the acclaimed ATTACK and has a built-in BEC (Battery Eliminator Circuitry) system.

Since the power receiver and servo power is supplied from the running

Nicd battery, there is no troublesome wiring and the vehicle can be made

lighter.

Thank you for purchasing a Futaba digital proportional radio control set.

Please read this manual carefully before using your set.

CONTENTS

AND

RATINGS

...........

TRANSMITTER PP-T2NCS/FP-T2NCR ..... 2

USING THE FREQUENCY FLAG

......

LOADING THE PENLIGHT BATTERIES . 3

SERVO

REVERSE

SWITCHES

........

STEERING TRIM LEVER ADJUSTMENT . 3

CHANGING THE THROTTLE STICK

FROM A SELF-NEUTRAL SYSTEM

A RATCHET SYSTEM

..........

CRYSTAL REPLACEMENT

..........

RECEIVER

AND

SERVOS

............

WHEN VEHICLE WILL NOT BE USED .

. C4

RECEIVER

ANTENNA

ROUTING

........

PP-S148

.....................

.C4

SPLINED HORNS

................

Summary of content (8 pages)

PAGE 1
Futaba DIGITAL PROPORTIONAL RADIO CONTROL D60656 ATTACK-SPORT SYSTEM FP-2NCS/2NCR •The ATTACK-SPORT is a high performance 2 channel digital proportional R/C set based on the acclaimed ATTACK and has a built-in BEC (Battery Eliminator Circuitry) system. Since the power receiver and servo power is supplied from the running Nicd battery, there is no troublesome wiring and the vehicle can be made lighter. Thank you for purchasing a Futaba digital proportional radio control set.
PAGE 2
The ATTACK-SPORT has a BEC function • The BEC (Battery Eliminator Circuitry) system is a high performance constant voltage circuit (regulator). Since the running Nicd battery can also be used as the receiver servo power supply, there is no troublesome wiring and the vehicle can be made lighter. • Transmitter is Built-in servo reverse switches. (FP-2NCR) SERVO FP-S148 RUGGED, LOW-PROFILE SERVO TRANSMITTER FP-T2NCS/T2NCR •Racing specification short aluminum stick lever makes operation extremely easy.
PAGE 3
• Nomenclature Before using the set, check the remaining battery capacity by checking the level meter. •The name of each part of the transmitter is shown in the figure. Learn them before operating your set. When running the vehicle, extend the antenna fully. Good Caution No good Change the battery.
PAGE 4
•LOADING THE PENLIGHT BATTERIES • Remove the battery cover at the rear and insert eight penlight batteries in the correct polarity. Rear cover mounting screws Servo reverse switches (FP-T2NCR) Slide in the direction of the arrow while pushing here. The batteries can be easily loaded by inserting them four at a time from the back. • Extend the antenna fully and set the power switch to ON. The level meter pointer should deflect to the silver zone.
PAGE 5
•CHANGING THE THROTTLE STICK FROM A SELF-NEUTRAL SYSTEM TO A RATCHET SYSTEM •When changing the throttle stick from a self-neutral system to a ratchet system, install the optional slider. Then, remove the spring and swing arm. Install the optional slider. Twist with long-nose pliers. Remove the spring and swing arm. •CRYSTAL REPLACEMENT • When changing the band, remove the crystal holder and change the crystal. (Except 72.75 MHz in USA) •Futaba Digital Proportional Frequencies (FOR U.S.A.
PAGE 6
mark is displayed on the front of the receiver of BEC The system sets with a receiver with shared power supply regulator. Receiver crystal Throttle servo Receiver FP-R102JE OFF ON Steering servo Connection to this connector Antenna wire Switch (1) When chassis power supply of engine or motor car is separate Wrapped with rubber bands.
PAGE 7
•Set the transmitter power switch to ON, then set the receiver power switch to ON. The servos stop near the neutral position. Operate the transmitter sticks and check if each servo faithfully follows operation of the sticks. From transmitter when switch turned on From receiver when switch turned off • Connect the pushrod to each servo horn, then check if the direction of travel of each servo matches the transmitter Operation.
PAGE 8
Your NEW FUTABA Digital Proportional R/C Systern is guaranteed against defects in workmanship and material for 180 days from the date of purchase when the attached registration card is returned to us within ten days of purchase. This Guarantee is null and void if the R/C system has been improperly handled, damaged in a crash, or tampered with and does not cover the replacement of plastic housings or electronic components damaged due to the use of improper voltages.