Manual

115
,QÀLJKWQHHGOHFRQWUROVHH
THROTTLE-NEEDLE
.
INH
PDNHVDIHDWXUHLQDFWLYHXQDEOHWREHXVHG:KHQDIXQFWLRQLVLQKLELWHGLWFDQQRWEHXVHGHYHQLIWKHDVVLJQHGVZLWFK
LV217XUQVRIIIXQFWLRQDOLW\ZLWKRXWORVLQJDQ\VHWWLQJV2QO\YLVLEOHLQVSHFL¿FIHDWXUHV
Inhibit: see
INH
.
Installation: radio installation and setup. ............................................................................................................................. 18
,QYHUWHGWRÀ\DPRGHOXSVLGHGRZQ
,QYHUWHGÀLJKWFRQWURO SURJUDPPLQJ QRW DYDLODEOHLQWKH & 0RVW PRGHOHUVQRORQJHUXVH WKLV LFUXWFKLWRÀ\LQYHUWHG
instead learning to recognize the modelis behaviors when inverted and compensate appropriately.
Kill switch: (1) throttle cut switch to close carburetor (see
THR-CUT
, p. 40). (2) gasoline ignition engine kill switch which
removes spark to the plugs to stop the engine. .................................................................................................................... 74
Launch setting: (
GLID
) see
START-OFS
.
Linear Mix: a mix that maintains the same relationship of master to slave throughout the whole range. Ex: a mix from
RQHÀDSVHUYRWRDQRWKHUÀDSVHUYRDWFDXVHVWKHQGVHUYRWRIROORZWKH¿UVWVHUYR¶VPRYHPHQWH[DFWO\WKURXJKDOO
points of travel. See Programmable mix.
LINK
: mixing function that allows multiple mixes to work in conjunction. See Programmable mix.
Lithium battery: see Backup battery.
Linear
: linear, directly proportional. See
AIRBRAKE
.
Low Band: 72MHz equipment on a channel from 11 to 35. Receiver channel may be changed to any channel within the
low band without needing retuning. ....................................................................................................................................... 8
LOGIC SW
: can be assigned to the following functions:
THR-CUT
,
IDLE DOWN
,
AUX-CH
,
TIMER
,
PROG. MIX
,
AIRBRAKE
,
ELEV-
FLAP
, and
AILE-FLAP
functions. The logic switch can activate functions by two switches combination. The 2 types of logic,
either AND or OR, can be selected. ..................................................................................................................................... 38
LOW BATTERY
ZDUQLQJWUDQVPLWWHU¶VEDWWHU\LVEHORZDVDIHÀLJKWYROWDJH5HFKDUJHLPPHGLDWHO\6HHError messages.
Low rate: see
D/R
,
EXP
.
MANUAL
: controlled by a switch. Ex: see
AIRBRAKE
.
Master: the primary control. See Programmable mix.
Mechanical gyro: uses a mechanical gyroscope (like a child’s toy gyro) to sense change of angle. See Gyros and
Governors.
MEMORY MODULE INITIALIZE
: warning to indicate that the CAMPac installed in the port is not yet formatted or formatted for
a different model of transmitter. Pressing the Dial initializes the CAMPac, deleting any existing data and formatting the
CAMPac for use in the 10C. See Error codes.
MHz: Megahertz. Unit used to express frequency. 72MHz channels are aircraft only frequencies; 75MHz are ground model
only frequencies; 27MHz are air and ground both. 50MHz is legal for HAM amateur license holders. See Frequency.
Mix, mixing rate, mix offset, mix links: See Programmable mix.
MIXER ALERT
ZDUQLQJQRWL¿HVXVHUWKDWDPL[LVDFWLYDWHGZKLFKLVQRWFRQVLGHUHGGHVLUDEOHIRUHQJLQHVWDUWXS6HHError
messages.
0RGHGH¿QLWLRQRIZKLFKFKDQQHOVDUHDVVLJQHGWRZKLFKSTICK movements. All 10C radios shipped in the US are Mode 2,
with elevator and aileron on the right STICK. To change mode, please visit www.futaba-rc.com.
MODE BUTTON: control button on radio’s face used in various parts of programming. ................................................. 11
MODEL COPY
: used to duplicate the settings of one model already in memory into a second model memory. Often used to