Instruction Manual

The audio is distorted
• Verify that the source volume is not too loud for the speaker, and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel are not rattling.
• Verify that the source device and/or the amplifier are connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the input level of the amplifier is matched to the output
level of the stereo. For more information, see the manual for the amplifier.
The LED lights will not turn on
• Verify that all wiring connections are correct and tight.
Specifications
Specification 4" Speakers 6.5" Speakers 7.7" Speakers
Peak power (Watts) 120 W 200 W 240 W
RMS power (Watts) 30 W 50 W 60 W
Efficiency (1 W/1 m) 87 dB 91 dB 92 dB
Frequency response 100 Hz to 18,000 Hz 80 Hz to 18,000 Hz 70 Hz to 18,000 Hz
Nominal impedance 4 ohms
Recommended amplifier power
(RMS)
15 to 80 W per channel 20 to 150 W per channel 25 to 200 W per channel
Min. mounting depth
(clearance)
54 mm (2
1
/
8
in.) 67 mm (2
5
/
8
in.) 77 mm (3 in.)
Mounting diameter (clearance) 99 mm (3
7
/
8
in.) 135 mm (5
5
/
16
in.) 162 mm (6
3
/
8
in.)
Optimum enclosure volume
recommendation*
4 L (0.14 ft.
3
) 8 L (0.28 ft.
3
) 10 L (0.28 ft.
3
)
LED color options (Sports
Model Speakers only)
N/A RGB
LED Supply Voltage (Sports
Model Speakers only)
N/A From 10.8 to 16 Vdc
LED Load Current at 14.4 Vdc
(Sports Model Speakers only)
N/A 150 mA
Operating temperature range From 0 to 50°C (from 32 to 122°F)
Storage temperature range From -20 to 70°C (from -4 to 158°F)
Cone/surround material
Polypropylene cone,
rubber surround
Polypropylene cone, cloth surround
Water and dust rating IEC 60529 IP65 (Protected against dust and water ingress.)
*Sealed enclosure, fully filled with absorption material.
NOTE: This speaker is not intended to be installed in a vented or ported enclosure when exposed to the outside
environment.
XS Series Installation Instructions 7