Fusion™ SG-VREGLED and MS-VREG121nstallation Instructions ......................................................................... 2 Instructions d'installation des appareils Fusion™ SGVREGLED et MS-VREG12 ............................................... 11 Fusion™ SG-VREGLED e MS-VREG12 lstruzioni di installazione ...................................................................... 21 Fusion™ SG-VREGLED und MS-VREG12lnstallationsanweisungen ..................................................
Fusionlll SG-VREGLED and MS-VREG12 Installation Instructions Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor product performance. See the Important Safety and Product Information guide in the product box for product warnings and other important information. ...-...., This device must be installed according to these instructions. -·- - - - - - -- - ----- ·- --·Disconnect the vessel's power supply before beginning to install this product.
• • 1 removable terminal block connector 2 mounting screws Depending on the model, this device either converts the voltage from your boat battery to a steady 12 Vdc (MS- · VREG12), or it regulates the voltage from your battery to power the LEOs on compatible Fusion speakers (SGVREGLED). The SG-VREGLED model also allows you to set the LEOs to dim with the boat lights and to select the color of the LEOs.
• The best location for the device is near the battery, in a protected area. NOTICE The 12 Vdc wiring from the battery to the regulator must run through a fuse near the power supply using a 5 A fuse (not included). You must connect the red power(+) wire to the fuse. The red power (+) wire should also connect to an isolator switch or circuit breaker to tum the regulator on and off.
Wire Function Minimum Gauge The REMOTE ON input wire and the DIM INPUT wire. 22AWG (0.3 mm2) MS-VREG12 Wire Function Minimum Gauge All power and ground wires from the boat battery, and all wires to the regulated device. 18AWG (0.8 mm2) Installing the SG-VREGLED Voltage Regulator Before you permanently install the voltage regulator, you should select a mounting location, make wiring connections, and test the wiring connections.
Item Description REMOTE ON You can connect to the stereo "Amplifier On" output to turn the regulator on and off with your stereo. You can connect to an isolator switch for manually-switched operation. You can connect to+ 12V IN for permanent operation. The positive wire from the boat battery. This wire must be connected through a 5 A fuse (not included) near the power supply. The negative or ground wire from the boat battery.
3 4 Item Description BLUE WHITE This control switches the LED color on the speakers between blue and white. DIM INPUT This control switches between two preset LED brightness levels. It can be connected to the boat lighting circuit. When connected to the boat lighting circuit, the LEOs on the speakers dim when the boat lights are turned on. You can adjust the LED brightness level using the BRIGHTNESS DIM ON and BRIGHTNESS DIM OFF controls. Use of these controls is optional.
Installing the MS-VREG12 Voltage Regulator Before you permanently install the voltage regulator, you should select a mounting location, make wiring connections, and test the wiring connections. 1 After you have selected a mounting location for the regulator and installed the fuse, route the appropriate cables to the mounting location. 2 Use a flat-blade screwdriver to connect the detachable connector on the regulator, based on the diagram and table.
3 4 Item Description GROUND IN The negative or ground wire from the boat battery. + 12V OUT The positive wire to the regulated device. GROUND OUT The negative wire to the regulated device. Test the regulator by turning on the boat and observing the regulated device. Secure the regulator to the mounting surface using the supplied screws. Model Specification Value All models Voltage input From 10.8 to 16 Vdc Input current 3A max. Output current Size (L x W x H) 1.5 A max. 110x62.4x 23.
Model LED Voltage Regulator (SGVREGLED) 12V Voltage Regulator (MSVREG12) 10 Specification Value Water rating IEC 60529 IPX2 (Withstands incidental exposure to dripping water when installed with the terminal block pointing downward.) Compass-safe distance 20 em (7.87 in.
Garmin't-, the Garmin logo, and the Fusion™ logo are trademarks of · Garmin Ltd. or its subsidiaries) registered in the USA and other countries. Fusion is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express ·permission of Garmin. CE: © 2015 Garmin Ltd. or its subsidiaries Printed in Taiwan www.garmin.
Important Safety and Product Information .....................:..................................... 2 Informations importantes sur le produit et Ia securite .......................................... 6 tnformazioni importanti sulla sicurezza e sui prodotto .. .. .. .. .. ... .. .. .. .. ... .. .. .. .. .. .. ... 10 Wichtige Sicherheits- und Produktinformationen ............................................... 13 lnformaci6n importante sobre el producto y tu seguridad .. ....... .. .. .. ...... .. .. ..... .
ImpOrtant Safety· an~ Product Information Failure to avoid the following potentially hazardous situations could resuH in an accident or collision resulting in death or serious injury. Marine Operation Warnings • You are responsible for the safe and prudent operation of your vessel. This device is a tool that wUI enhance your capability to operate your vessel. It does not relieve you from the responsibility of safely operating your vessel. . Avoid navigational hazards and never leave the helm unattended.
Product Environmental Programs Information about the Garmin• product recycling program and WEEE, RoHS, REACH, and other compliance programs can be found at www.garmin.com /aboutGannin/environment. Declaration of Conformity Hereby, Gannin declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. To view the full Declaration of Conformity, go to www.garmin.com/compliance. Software Ucense Agreement .
of defects at the time of shipment and, therefore shall not be covered under these limited warranty terms. • Repaired product will be warranted for the balance of the original warranty period or for ninety (90) days from the date of repair, whichever is longer. • All warranty claims must be accompanied with a copy of this warranty card, and a copy of proof of purchase.
• Applicable law may not allow the limitation or exclusion of liability in some situations therefore the above limitations or exclusions may not apply to you. • Fusion neither assumes nor authorises any authorised service centre or any person or entity to assume for it any other obligation or liability beyond that which is expressly provided for in this warranty. • All warranty information, product features and specifications are subject to change without notice.
• Unauthorised modifications of product, connections or otherwise unauthorised repairs including, but not limited, to the use of unauthorised parts in the repair of products. • Improper use of or installation of, or interference with, product adjustments or controls and or including antenna breakage or damage due to misuse. • Damage caused by consumables or by electricity supply. • Acts of god (force majeure), exposure of product to food spills, or any other type of fluid ingress.
© 2015 Garmin Ltd.
