User / Installation Manual Marine Zone Amplifier MS-AM702 www.busse-yachtshop.de | info@busse-yachtshop.
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pg 3 Before any wiring and installation is performed, FUSION recommends you first plan the complete installation. Look at wiring routing, amplifier location and mounting options. Please re-check the installation at completion. Appropriate mounting is very important for prolonged life expectancy of any amplifier. Installation Warning . . . . . . . . . . . . . . . . . . . .
The use of an inline fuse at the battery position is essential. This will prevent the risk of a potential fire caused by a short circuit in your power cable. Connect the fuse holder as close to the battery positive terminal as possible. You may now connect the cable to the battery, but remember to leave the fuse out or circuit breaker off until all other cable connections are made. Avoid running the power cable over engine components.
SPECIFICATIONS WIRING 006 2 007 SPECIFICATIONS CONTROL DESCRIPTIONS Operating Range +10-16Volts DC / Negative Ground 4 20 Watts RMS at 4 Ohms per channel @1%THD+N 33 Watts RMS at 2 Ohms per channel @1%THD+N S/N Ratio @ 1kHz / 1W Reference -- 84dB 1 High Pass x-over - 60Hz – 600Hz 3 Maximum Operating Current - 8 AMPS THD 10% @ 1kHz / 4 Ohm Load per channel 6 For further product and installation information please visit www.fusionelectronics.
Specifications and design are subject to change without notice. www.busse-yachtshop.de | info@busse-yachtshop.
