Owner's Manual
RV-FS402
Spacer
Failure to follow
these warnings and cautions
could result in
personal injury, damage to the vessel,
or
poor product
performance.
See
the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
This device must be
installed according to these instructions.
~
•
_.
" - • • ., .
"•
'
~'-
'"'-
·"
·'·
-
·
H'
'
o'00
~'-'>
~~
-
-
· -
-
~--~-----
·
• • o • •
r
o•
•·
-···--·--
•• •
Disconnect the vessel's power supply before beginning to install
this product.
/ll.CAUTION
Audio systems can produce sound pressure levels exceeding
135 dB. Continuous exposure
to
sound pressure levels over
100
dB may cause permanent hearing loss. The volume is
typically
too loud if you cannot
hear people speaking around
you. Limit the amount
of
time you listen at high volume. If
you
experience ringing in your ears
or
muffled speech, stop listening
and have your hearing checked.
Always wear safety goggles, ear protection, and a dust mask
when
drilling,
cutting,
or
sanding.
NOTICE
When
drilling
or
cutting, always check what is on the opposite
side
of
the surface.
It
is strongly recommended that you have your audio system
installed by a professional installer
to
ensure optimum
performance.
You must read
all installation
instructions before beginning the
installation.
If
you experience difficulty during the installation, go
to www.fusionentertainment.com for product support.
Tools Needed
• Screws
appropriate for the depth
of
the spacer and for the
surface material
•
Electric
drill
• Drill
bit (size varies based on surface material)
•
Screwdriver
• Appropriate saw
or
utility knife to cut surface material
•
Marine sealant (optional)
NOTE:
For customized installations, additional tools and
materials may be needed.
Installing
the Spacer
1
Select
and prepare the mounting surface as directed
in
the
RV-FS402
Installation Instructions.
2
If
you are installing the speaker and spacer i
n an external
location, apply marine sealant between the spacer and the
mounting surface (optional).
3
Place
the spacer
G)
over the
installation location @.
f(
~
:
~~
~
i
~__,/
p
i
/
•I
' /
)J-~
:<
~
1,
1
r-
1
.1
~
l i
I
1:/
j
!!
I.
Ji1r//
.
I
/'"
1
:•.
]i
:
J-
....--...---1
!
it'
~
~
r!
/
t--~·~;
Li
/
~~
2
4
Secure
the spacer to the surface using the screws included
with the spacer
(;3
!
or
screws appropriate for the depth
of
the
mounting surface.
5
Make the necessary wiring connections as directed
in
the
RV-FS402
Installation Instructions.
6
Place the speaker
'!\)
on the spacer, and secure it to the
spacer using the screws included with the speaker
(~)
.
7 With the
FUSION•
logo in the correct orientation for your
installation, press the
grille
frame onto the speaker to snap
all
of
the connectors into place.
Insta
ll
ation Ins
tr
uctions