Owner's Manual

• Select MANUAL to select a station
manually.
• Select PRESET to select a saved
station preset.
3 Select M ◄ or ► M to tune to the station .
When in MANUAL tuning mode , you can
hold M ◄ or ► M to quickly advance
through the stations.
Saving a Station as a Preset
1 With an applicable source selected , tune
the stereo to a station.
2 Select 5 > PRESETS.
3 Select SAVE CURRENT .
TIP: You can quickly save the selected
station as a preset by holding ► n .
Scanning for DAB Stations
NOTE: Because DAB signals are broadcast
in select countries only, you must set the
tuner region to a location where DAB signals
are broadcast.
1 Select the DAB source .
2 Select ► n to scan for available DAB
stations .
When scanning is complete, the first
available station in the first ensemble
found begins playing .
NOTE: After the first scan is complete ,
you can select ► 11 again to re-scan for
DAB stations. When the re-scan is
complete, the system starts playing the
first station in the ensemble you were
listening to when you started the re-scan .
Connecting to a Garmin ® Watch
For more information about the watch, see
the watch manual at www . garmin.com
/ manuals.
1 Following the instructions in the watch
manual , install the Fusion-Link Lite ™ app
from the Connect IQ .... store onto the
watch.
2 On the stereo, select the BT source.
3 Select 5 > DISCOVERABLE.
The stereo remains discoverable for two
minutes.
4 Bring the watch within 3 m (10 ft.) of the
stereo.
NOTE: Stay 10 m (33 ft.) away from
other ANT devices while pairing .
5 Open the Fusion-Link Lite app on the
watch .
The first time you open the app on the
watch, the watch automatically pairs with
and connects to the stereo . If you need
to pair to another stereo, in the Fusion-
-- ------
Qui ck St a rt M anu al
5