Owner's Manual

Specifications
Compass-safe distance 75 cm (30 in.)
Operating temperature range From -0 to 50°C (from 32 to 122°F)
Storage temperature range From -20 to 70°C (from -4 to 158°F)
Water rating IEC 60529 IPX2
1
Maximum wire gauge
Power: 2 AWG (33.63 mm
2
)
Speakers: 10 AWG (5.26 mm
2
)
Weight 2.2 kg (4 lbs 13.6 oz)
Amplifier class Class D
Frequency response 20 Hz to 3.5 kHz (4 Ohm)
CEA-2006 power rating @ 14.4 Vdc, 4 Ohm, ≤ 1%
THD+N, 50 Hz, AES17-20 kHz BW
650 W RMS
CEA-2006 power rating @ 14.4 Vdc, 2 Ohm, ≤ 1%
THD+N, 50 Hz, AES17-20 kHz BW
1100 W RMS
Peak power output 2000 W
Input impedance 22 kOhm
Input sensitivity @ rated power output, 4 Ohm 2.15 Vrms
Signal to noise ratio @ rated power output,
4 Ohm
101 dBA
Signal to noise ratio @ 1 W, 4 Ohm 75 dBA
Operating voltage 10.8 to 16 Vdc
Current draw, standby (@14.4 Vdc input) less than 5 mA
Current draw, on, no audio (@14.4 Vdc input) 1.15 A
Breaker or cable-fuse rating
If the amplifier is powered by a battery, use a breaker or
fuse rated to protect a cable of the gauge used to connect
the amplifier to the battery. See the ABYC standards for the
required fuse or breaker rating.
If the amplifier is powered by a source other than a battery,
use a breaker or fuse rated no higher than the max current
of the power source.
Internal fuse rating
Internal electronic fuse. No replacement necessary.
125 A
Remote turn-on Greater than 4 Vdc
Protection circuits
Reverse voltage
Input under/over voltage
Over temperature
Output short circuit
1
Protection against vertically-dripping water when installed properly with the connectors pointing downward.
12 Fusion Apollo MS-AP12000 Monoblock Amplifier Installation Instructions Installation Instructions