Owner's Manual

Completing the Connections
Before you connect the amplifier to the power source, you should complete all other connections to the
amplifier .
1 Make sure the speaker wire is connected between the subwoofer and the amplifier, using a speaker terminal
block.
2 Make sure the RCA cable is connected between the stereo and the amplifier.
3 Make sure the power and ground cables are connected to power terminal block and the power source
(Connecting to Power, page 8).
4 Make sure the amplifier remote-on wire is connected to the power terminal block and to the amplifier turn-
on wire from the stereo (Connecting to Power, page 8).
5 Insert the assembled power terminal block into the power port on the left side of the amplifier.
6 Using a 5 mm (
7
/
32
in.) flat (slotted) screwdriver, secure the power terminal block to the amplifier.
NOTICE
After you have completed all connections, you must configure the DSP profile for the amplifier before playing
music. If the DSP profile is not set up, you may damage the connected speakers (Configuring the Amplifier,
page 11).
Configuring the Amplifier
To configure the amplifier for use with your stereo and speakers, you must use the Fusion-Link app to set up
the DSP profile after you have completed the connections.
TIP: You can view a video tutorial to help setup a DSP profile for your system at garmin.com/videos/fusion_link
_app.
1 Follow the instructions in your stereo owner's manual to download the Fusion-Link app and connect it to the
stereo.
2 Select the appropriate amplifier, speakers, and/or subwoofer(s) for each zone in the Fusion-Link app.
3 Follow the instructions in the Fusion-Link app to select a configured profile for the connected amplifier,
speakers, and/or subwoofer(s).
4 Send the DSP profile to the connected stereo and test the sound.
5 Repeat steps 3 and 4 until the audio system sounds satisfactory.
Fusion Apollo MS-AP12000 Monoblock Amplifier Installation Instructions Installation Instructions 11