Manualshelf

Operator's Manual

ManualsBrandsFuruno ManualsInstrumentsFuruno RD50
61626364656667686970
4. INSTALLATION
4-14
Connection of WAGO connector
Remove the WAGO connector from each unit and connect each cable core to the
WAGO connector. See the interconnection diagram (page S-1). The terminal opener
is attached inside the remote display at the location shown in the illustration below.
Remote display, rear panel
WAGO connector
Ground terminal
Cable entrance
Fuse
Terminal opene
r
Procedure
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
Terminal opener
How to connect wires to WAGO connector
WAGO connector
Wire
Twist
Press downward.