Operator's Manual

4. INSTALLATION

4-2

Flush mounting

See the outline drawing in the back of this manual.

1. Make a cutout in the mounting location as shown in the illustration below.

2. Make four pilot holes for self-tapping screws (diameter: 5 mm) in the location in-

dicated in the illustration below.

3. Insert the sponge to the remote display from the rear side.

4. Set the remote display to the cutout and fasten the remote display with four self-

tapping screws (5x20).

5. Set a cosmetic cap to each fixing hole on the front panel. (See “How to set the

cosmetic cap” on page 4-4.)

Note: When you fasten the remote display to the cutout after you connect the cable to

the remote display, first connect the cables referring to section 4.5.

Desktop or table underside mounting

The remote display can be mounted on a desktop or on the underside of a table using

the optional hanger. See the outline drawing for details.

Hanger assembly (Type: OP26-8, Code No.: 000-016-313-00)

Name Type Code No. Qty

Self-tapping screw 5x20 000-171-997-10 4

Binding head screw M5x12 000-171-999-10 4

Hanger assy. OP26-8-1 001-081-920-00 1

78 (3.07”)

12 (0.47”)

240 (9.45”)

Fixing hole (4-ø6)

Cutout

Pilot hole (4 places)

223 ± 0.5 (8.78”)

228 ± 1 (8.98”)

18 (0.71”)