Operator's Manual

3. INSTALLATION

3.5 Adjustments

After wiring each unit, initialize each remote display as follows:

1. While you hold down the MODE key, press the PWR key to turn on the power.

Note: If you press the MODE key with this screen shown, the equipment restarts.

2. Press T key to select the screen for [YES].

3. Press the MODE key. The screen for speed appears.

4. Press T or S key to change the setting.

5. Press the MODE key to go to the next screen. Use T or S key to change the setting.

6. Repeat step 5 to set all menus. You can use the UNIT key to return to the previous screen.

7. After you set all menus, press the MODE key with the screen for [ALL CLEAR]. The equipment

restarts.

Note: The system menu is inoperative on the RD-501 and RD-502.

SYS MENU

MODE

SYS MENU

YES

MODE