Installation Instructions

3. INITIAL SETTINGS
3-37
3.16 SYSTEM SETUP Menu
SAVE ENGINNER SETTING: Save the settings in the menus with the following excep-
tions:
• DISPLAY SETUP (except DATA BOX FORMAT, TEMP GRAPH)
• DOCKSIDE SETUP (except SELECT RRU TYPE, RRU SENSOR ALIGNMENT,
AIR BLEEDING, RUDDER LIMIT SETUP, RUDDER TEST, HELM SENSOR TEST)
• CAN BUS SETUP (except INCOMING CAN BUS DATA, REFRESH)
• NMEA 0183 SETUP PORT1, PORT2 (except REFRESH)
• SENSOR SELECTION (except AUTO DETECT)
• SEA TRIAL (except COMPASS, COMPASS CALIB., RESTART PG-700, COM-
PASS CLEAR, COMPASS INFORMATION, SET CENTER RUDDR POS)
• SYSTEM SETUP (KEY BEEP, BUZZER VOL, KEY LOCK, PANEL DIMMER,
RECEIVE SCREEN, ALL CLEAR, SAVE/LOAD USER SETTINGS, SAVE/LOAD
ENGINEER SETTING, DIAGNOSTIC, DISPLAY DATA SELECT MENU, SYSTEM
DATA)
• ALARM MENU (CLEAR TRIP LOG)
LOAD ENGINEER SETTING: Load the settings saved with SAVE ENGINEER SETTING:
For other items, section 4.6 “SYSTEM SETUP menu” in the Operator’s Manual.
Page 1
SYSTEM SETUP
KEY BEEP: OFF
BUZZER VOL: LARGE
ARROW KEY: DODGE
KEY LOCK: UNLOCK
TURN ANGLE: 15
PANEL DIMMER: 8
PASSWORD: 0000
PASSWORD FUNCTION: OFF
ALARM CLEAR
RECEIVE SCREEN: OFF
SAVE USER SETTING: NO
LOAD USER SETTING: NO
SAVE DISPLAY SETTINGS: NO
SYSTEM SETUP
LOAD DISPLAY SETTINGS: NO
SAVE ENGINEER SETTING: NO
LOAD ENGINEER SETTING: NO
ALARM LOG
SIM/DEMO: OFF
DIAGNOSTIC: OFF
DISPLAY DATA SELECT MENU
SYSTEM DATA
Page 2