Installation Instructions

3. INITIAL SETTINGS
3-2
3.2 How to Select Language and Units, Open the
Installation Menu
1. Press the POWER/BRILL key (NAVpilot-700) or the POWER/STBY key (NAVpilot-
711/720) to turn on the power. The splash screen appears followed by the startup test
and the language selection menu, shown below. The default language is
English(USA). If you don’t need to change the language, push the knob and go to step
2. To change the language, rotate the knob to select a language then push the knob.
2. Press the X key to show the [UNIT SETUP] menu.
3. The units on the [UNIT SETUP] menu are set according to the language selected. If
you require different units, change them as follows.
1) Rotate the knob to select the setting to change then push the knob.
2) Rotate the knob to select a unit then push the knob.
4. Press the X key to show the [OPERATION MODE] menu.
ENGLISH(USA)
ENGLISH
FRANCAIS
ESPANOL
PORTUGUES
DEUTSCHE
ITALIANO
NORSK
DANSKE
SVENSKA
SUOMI
UNITS SETUP
SPEED UNIT: kn
RANGE UNIT: nm
WIND SPEED UNIT: kn
DEPTH UNIT: ft
WATER TEMP UNIT: °F
PREV  NEXT 
OPERATION MODE
INSTALLATION
DEMO SLIDE SHOW
SIMULATOR
PREV  NEXT ENTER