Installation Instructions

1. INSTALLATION

1-9

1.4 Remote Controllers (option)

Two remote controllers may be connected to the Processor Unit. To connect three NFU-

(Non-Follow Up) type remote controllers (button and lever) to the Processor Unit, connect

them via the optional Distributor FAP-6800.

Keep the remote controllers away from areas subject to rain and water splash.

Note: For Fantum Feedback

, the remote controller can not be connected.

Dial-type remote controller FAP-5551/FAP-5552

Fasten these remote controllers to a bulkhead. They can also be mounted on the bulk-

head by using the optional bracket assembly OP64-2 (Code No.: 009-004-030).

FAP-5551, bulkhead, bracket mount

For handheld operation in the opposite direction, reverse the switch and dial blocks so that

the dial is readable. To do this, loosen the four screws shown below. Note that the switch

and dial blocks are inserted into the controller body with O-rings. Be careful not to damage

them.

How to reverse the switch and dial blocks

Bulkhead mount

Bracket mount (with optional bracket assembly OP64-2)

70(2.76”)

60(2.36”)

119(4.7”)

(1.54”)

17.5

(0.69”)

125

(4.92”)

(2.44”)

(1.3”)