Operator's Manual

APPENDIX 5 ALERT LIST
AP-58
638 Permit Expired Warning
When Permit Expired is set
to Warning/Caution in chart
alert,
Be careful of the object
mentioned left, on ship's di-
rection.
640 Chart align: Over
30 min
Caution
Own ship position has been
offset for more than 30
minutes.
Reset offset.
652 Last WPT
Approach
Alarm
Ship will reach last
waypoint in 30 seconds.
Be careful that last way-
point is approaching.
665 Autopilot Mode
Conflict
Alarm
In communication between
AP, TCS mode of ECDIS
and AP are different.
Check the mode in autopi-
lot.
667 AP Receive Error Caution
Communication between
AP and ECDIS is
discontinued.
Check the connection with
autopilot.
675 Use MAN
Steering
Warning
All GPS signals are lost
during track control, and
track control has been
continued for 10 minutes in
DR. Alarm generates every
2 minutes.
Switch autopilot mode to
manual or auto.
690 TC Start Timeout Alarm
Operation to start track
control in autopilot is not
performed in 30 seconds
after performing the
operation to start track
control in ECDIS.
*Currently not used
because TCS start
operation is caused by
autopilot.
Perform operation to start
track control again.
691 RM Stop - Exceed
Max XTE
Alarm
Route monitoring is
stopped because distance
from route is more than set
value of Max XTE.
Start route monitoring after
approaching the monitoring
route.
692 RM Stop - Discon-
nect Sensors
Alarm
Error occurs inside of route
monitoring function.
If the error frequently oc-
curs, contact FURUNO and
inform frequency of occur-
rence.
693 RM Stop - Other
Causes
Alarm
Required data for route
monitoring such as
position, SOG/COG cannot
be acquired.
Check the connection with
GYRO, GPS and SDME.
820 NAVTEX Message
Received
Caution NAVTEX message is re-
ceived.
-
No. Text Default Meaning Remedy