SONAR User Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- FOREWORDa
- SYSTEM CONFIGURATION
- 1. OPERATIONAL OVERVIEW
- 2. HORIZONTAL MODE
- 2.1 Operational Overview
- 2.2 Typical Horizontal Mode Display
- 2.3 Selecting the Range
- 2.4 Selecting Sector Width
- 2.5 Selecting Train Center
- 2.6 Selecting the Tilt Angle
- 2.7 Selecting the Training Speed
- 2.8 Finding Echo Position with the Cursor
- 2.9 Event Marker
- 2.10 Depth and Horizontal Range Markers
- 2.11 Adjusting the Picture
- 2.12 Target Lock
- 2.13 Horizontal Menu Overview
- 2.14 Interpreting the Horizontal Display
- 3. VERTICAL FAN MODE
- 3.1 Operational Overview
- 3.2 Typical Vertical Fan Mode Display
- 3.3 Selecting the Range
- 3.4 Selecting Train Center
- 3.5 Selecting Display Sector
- 3.6 Selecting Sector Center
- 3.7 Selecting the Training Speed
- 3.8 Finding Echo Position with the Cursor
- 3.9 Event Marker
- 3.10 Depth and Horizontal Range Markers
- 3.11 Adjusting the Picture
- 3.12 Vertical Menu Overview
- 3.13 Interpreting the Vertical Fan Display
- 4. ECHO SOUNDER MODE
- 5. MENU OPERATION
- 6. MAINTENANCE, TROUBLESHOOTING
- MENU TREE
- SPECIFICATIONS
- INDEX
5-16
5.4.3 Vertical fan mode range settings
As with the horizontal mode, the user may preset the vertical fan mode’s ranges.
1. Select RANGE-VER MODE at the SYS menu and then press
.
2:20
3:30
4:40
10 : 200
11 : 250
12 : 300
13 : 400
14 : 500
15 : 600
DEFAULT SETTING : NO YES
: SELECT
: CHANGE MENU: END
1:10 (10-600m)
5:60
6:80
7 : 100
8 : 120
9 : 160
** RANGE-VER MODE **
Figure 5-14 Range-ver mode menu
2. Press
or to select range number desired.
3. Press
or to set range.
4. To restore default vertical fan mode range settings, select DEFAULT SETTING, press
to
select YES and press the [MENU] key.
5. Press the [MENU] key to register settings and close the menu.