SONAR User Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- FOREWORDa
- SYSTEM CONFIGURATION
- 1. OPERATIONAL OVERVIEW
- 2. HORIZONTAL MODE
- 2.1 Operational Overview
- 2.2 Typical Horizontal Mode Display
- 2.3 Selecting the Range
- 2.4 Selecting Sector Width
- 2.5 Selecting Train Center
- 2.6 Selecting the Tilt Angle
- 2.7 Selecting the Training Speed
- 2.8 Finding Echo Position with the Cursor
- 2.9 Event Marker
- 2.10 Depth and Horizontal Range Markers
- 2.11 Adjusting the Picture
- 2.12 Target Lock
- 2.13 Horizontal Menu Overview
- 2.14 Interpreting the Horizontal Display
- 3. VERTICAL FAN MODE
- 3.1 Operational Overview
- 3.2 Typical Vertical Fan Mode Display
- 3.3 Selecting the Range
- 3.4 Selecting Train Center
- 3.5 Selecting Display Sector
- 3.6 Selecting Sector Center
- 3.7 Selecting the Training Speed
- 3.8 Finding Echo Position with the Cursor
- 3.9 Event Marker
- 3.10 Depth and Horizontal Range Markers
- 3.11 Adjusting the Picture
- 3.12 Vertical Menu Overview
- 3.13 Interpreting the Vertical Fan Display
- 4. ECHO SOUNDER MODE
- 5. MENU OPERATION
- 6. MAINTENANCE, TROUBLESHOOTING
- MENU TREE
- SPECIFICATIONS
- INDEX

5-12
SYSTEM SETTING 2 menu description
OFF ON
OFF (OFF, 5-15kt)
AUTO RETRACTION :
SPEED ALARM/MESSAGE
:
DEFAULT SETTING : NO YES
: SELECT
: CHANGE MENU: END
MENU
1 2
** SYSTEM SETTING 2 **
MAXIMUM ALLOWABLE SPEED IS 15 KNOTS WHILE SOUNDDOME IS BEING
RETRACTED. IF VESSEL HAS RAPID ACCELERATION CAPABILITIES,
AUTO RETRACTION SETTINGS OF 10-12 KNOTS ARE MANDATORY TO
AVOID CATASTROPHIC DAMAGE TO SOUNDOME ASSY. ANY PHYSICAL
DAMAGE TO THE SOUNDOME ASSY. IS CONSIDERED ABUSE AND IS
NOT A WARRANTY ISSUE.
SOUNDOME SERIAL NO
: -999 1000-
STABILIZER :
OFF ON
SWEEP INDICATOR : DOT LINE
Figure 5-11 System setting 2 menu
STABILIZER: Choose ON to compensate for effects of ship’s pitching and rolling. Requires
Motion Sensor MS-100 or Clinometer BS-704.
AUTO RETRACTION: Turn on to automatically retract the transducer when ship’s speed
exceeds the speed set here. The ship’s speed range for automatic retraction is from 5 to 15
knots. The default setting is OFF (no automatic retraction). Requires speed input.
Note: The transducer may be retracted at a speed other than the intended one when ship’s
speed data is erroneous.










