SONAR User Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- FOREWORDa
- SYSTEM CONFIGURATION
- 1. OPERATIONAL OVERVIEW
- 2. HORIZONTAL MODE
- 2.1 Operational Overview
- 2.2 Typical Horizontal Mode Display
- 2.3 Selecting the Range
- 2.4 Selecting Sector Width
- 2.5 Selecting Train Center
- 2.6 Selecting the Tilt Angle
- 2.7 Selecting the Training Speed
- 2.8 Finding Echo Position with the Cursor
- 2.9 Event Marker
- 2.10 Depth and Horizontal Range Markers
- 2.11 Adjusting the Picture
- 2.12 Target Lock
- 2.13 Horizontal Menu Overview
- 2.14 Interpreting the Horizontal Display
- 3. VERTICAL FAN MODE
- 3.1 Operational Overview
- 3.2 Typical Vertical Fan Mode Display
- 3.3 Selecting the Range
- 3.4 Selecting Train Center
- 3.5 Selecting Display Sector
- 3.6 Selecting Sector Center
- 3.7 Selecting the Training Speed
- 3.8 Finding Echo Position with the Cursor
- 3.9 Event Marker
- 3.10 Depth and Horizontal Range Markers
- 3.11 Adjusting the Picture
- 3.12 Vertical Menu Overview
- 3.13 Interpreting the Vertical Fan Display
- 4. ECHO SOUNDER MODE
- 5. MENU OPERATION
- 6. MAINTENANCE, TROUBLESHOOTING
- MENU TREE
- SPECIFICATIONS
- INDEX
5-1
5. MENU OPERATION
This chapter provides menu operating information on menus not previously discussed: COM1,
COM2, PRESET (or SHORT-CUT, depending on the setting of CUSTOM KEY on the SYSTEM
SETTING 1 menu) and SYS (System) menu.
5.1 COM1 Menu
1. Press the [MENU] key to open the menu.
2. Press
to select MENU, and then press to select COM1.
TX POWER MAX
PULSELENGTH LONG
TX RATE 10
INT REJECT OFF
AGC OFF
: SELECT
: CHANGE MENU: END
MENU
COM1 HORZ VERT ES PRESET SYSCOM2
AUDIO LEVEL 0
Figure 5-1 COM1 menu
3. Press
or to select item; or to open associated dialog box.
4. Press
or to select option desired.
5. Press
or to return to the COM1 menu, or press the [MENU] key to register your
selection and close the menu.