Installation Instructions

U.S.A .
BBWX3 INSTALLATION GUIDE
Page 6 of 13
2.2 Receiver/Switch Specifications
SiriusXM Weather Marine Inland, Marine Coastal, Marine Offshore
SiriusXM Radio Analog Output: 0 dBm into 600 Ω (0 dBv)
Transmission speed Half-duplex/Full-duplex; 10 Mbps/100 Mbps
I/O Ports 1 Port (Shielded RJ45)
Environmental Conditions
Ambient Temperature -15 to 55 °C
Relative Humidity 95%, 66°C, 18 hours
EMC IEC 60945 Rev 4, Sections 9.2 & 9.3
Water Ingress IPX7 (IEC 60529)
Power Supply 12 – 24 VDC, 0.4 A(<3.0 Watts)
Body Color Matte Black
2.3 Equipment List
Name Type Code No. Qty Remarks
BBWX3
XXXXXX BBWX3
1 Receiver
Installation
Materials
- -
1 Power cable
- -
1 Audio Cable
- -
1
SMA to SMB
Adaptor Cable
- -
1 Ethernet Cable
- -
1 set Mounting Bracket/screws
Not provided
Ethernet
Cables
(not
included)
4 Pair LAN Cable Assy 001-167-880-10
2m For Navnet 3D
4 Pair LAN Cable Assy 001-167-890-10
5m For Navnet 3D
4 Pair LAN Cable Assy 001-167-900-10
10m For Navnet 3D
4 Pair LAN Cable Assy 000-164-609-10
3m
Cable with waterproof
Connector for MFD8/12
U.S.A .
BBWX3 INSTALLATION GUIDE
Page 7 of 13
3.0 BBWX3 Installation
The BBWX3 does not come standard with a SiriusXM satellite antenna or antenna cable. These
must be purchased separately. The BBWX3 is compatible with two Shakespeare antenna models:
 SRA-40
 SRA 25
Furuno USA carries the following:
WX1-005-003 Shakespeare SRA-40 antenna
WX1-005-004 25' BBWX3 Antenna Cable
For installations that require longer cable lengths you may contact your local Shakespeare
outlet for options.
3.1 Mounting Considerations
The BBWX3 can be mounted on a desktop or a bulkhead. When choosing a mounting
location, keep in mind the following points:
 Locate the unit well away from areas subject
to intense splashing, rain and direct sunlight
 Locate the unit away from the vessel engines
or where fuel vapor may be present
 Locate the unit in an environment inside the
operating and storage temperature ranges
 The power cable supplied is 3.0 meters,
however it can be extended up to 20 meters
 If bulkhead mounting, the cables should
protrude out the bottom, not the top. This will
prevent any possible water (moisture) from
wicking into the unit from the cables
Note: The Antenna and Receiver should be mounted away from electromagnetic interference
(e.g. >1.5 meters away from an AIS or radio transmitter, >2.0 meters away from Radar,
>1.8 meters from a compass).
Fix the unit to the mounting location with the two self-tapping screws provided.
4
5