User's Manual

Monitor Installation
When choosing a location to mount the monitor, make sure the monitor is in
an area that will not obstruct your vision while driving.
1. Before mounting the monitor, clean the mounting surface well.
2. Position the suction mount to the smooth surface which suits your
requirement.
3. Press the suction cap against the smooth surface and press the lock
down to attach and fix the mount to the surface.
Snap in the monitor to the suction mount.
4. Adjust the mounting arms to suit your view angle to the monitor and
tighten the screws on the mount to fix the position.
5. Route the power cable to the vehicle’s cigarette lighter socket/12/24 V
power outlet. The cable must not interfere with the safe operation of the
vehicle.
6. Insert the small 12/24 Volt DC plug of the power cable into the right side
of the monitor.
7. Plug the 12/24 Volt cigarette lighter plug into the vehicle’s cigarette lighter
socket.
To maximize the effectiveness of the suction mount, it is recommended that the
application be performed under the following conditions:
• Surface temperature should be between 21 and 38 degrees Celsius.
• Application below 10 degrees should be avoided.
• Application should not occur in direct sunlight.
Mounting should be protected from exposure to direct sunlight for a period
of 24 hours.
NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN
IMAGE MAY TAKE A FEW SECONDS TO STABLIZE. PLEASE WAIT UNTIL
THE IMAGE HAS STABLIZED BEFORE BACKING UP.
10