Owner's Manual

19
Getting Started
The Setup Wizard window appears only the
first time you turn on the TV. It will assist you
to configure the TV and scan for available
channels.
IMPORTANT: Make sure the antenna or
cable connection is made.
1. Press POWER button on the TV control
panel or button on the remote control
to switch on the TV. The Setup Wizard
window appears on the screen.
NOTE: It may take a few seconds before
the Setup Wizard window appears on the
screen.
2. Use / / / to navigate and select
your desired settings.
Setup Wizard
Air/Cable Air
Cable System Auto
Auto Scan
Menu Language English
Move
Select
Exit
MENU
Setup Wizard
Menu
Language
Use or to highlight Menu
Language, then press or to select
English, French or Spanish.
Air/Cable
Use or to highlight Air/Cable,
then press or to select Air or
Cable.
Cable
System
Use or to highlight Cable
System, then press or to select
Auto, STD, IRC or HRC.
NOTE: Only adjustable when “Air/
Cable” is set as “Cable” mode.
Auto Scan
Use or to highlight Auto Scan,
then press OK or to start scanning all
the channels available in your area.
NOTE: You may press MENU at any time to
exit the menu.