Owner's Manual

English
8
2. Insert the plug of the appropriate adapter into the DC
input socket for power supply. (Fig. 14)
Fig. 14
ePod
TM
Battery
1. Open the battery compartment lid by pulling the latch
upwards.
2. Remove the terminal cap at the bottom of the battery
compartment by unscrewing the 2 fastening screws.
(Fig. 15)
Fig. 15
3. Block the screw holes with 2 screw plugs (provided).
(Fig. 16)
Fig. 16
4. Insert fully the ePod
TM
battery into the battery
compartment with the icons on the battery and cooler
aligned. Close the lid afterwards. (Fig. 17)
Fig. 17
It is recommended to clean the cooler before first use. For
detail cleaning instructions, please refer to section Cleaning
Instruction.
Getting Started
Power Input
Select the appropriate power source:
NOTE:
The 400Wh ePod
TM
battery is purchased separately and
can be used as a standalone power source. The solar panel
is also purchased separately but can not be used as a
standalone power source, it must be used in combination
with the 400Wh portable ePod
TM
battery.
1
AC/DC
Adaptor
Converts 120VAC
from the wall to DC to
power the cooler.
2
Cigarette
Lighter
Plug
Connect directly to
DC power from the
Car or RV to power
the cooler..
3
400WH
Portable
ePod
TM
Battery
Power the cooler.
Can be charged by
AC/DC Adaptor,
Cigarette Lighter Plug
or Solar Panel.
4
Solar
Panel
Using the 100W solar
panel to charge the
ePod
TM
battery.
NOTE:
The AC/DC adapter is for indoor use only. Do not use it
outdoors.
Power Input Connection
AC/DC Adapter, DC (Cigarette Lighter) Plug
1. Open the DC input socket cover. (Fig. 13)
DC Input Socket
Fig. 13
Operation