Owner's Manual

ManualsBrandsFurrion ManualsGPS & car accessoriesFAN73B7C-BL-A

1

2

3

4

5

6

7

8

9

8

Installation

with the cutting hole in the RV roof.

Fig. 10

7. Fix the antenna base on the RV roof

using seven stainless steel self-

tapping screws and tighten using a

screwdriver. (Fig. 11)

****

NOTE: Do not overtighten as damage

to the base may be occur, which will

void the warranty. A screw angle up

to 30 degrees is acceptable without

damaging the base.

Fig. 11

8. Apply a liberal amount of sealant

around the antenna base and

the screw holes to prevent water

leakage if necessary. Check with the

RV manufacturer for the standard

sealant for the vehicle. (Fig. 12)

****

For FAN73B7C-BL3, six screws are

needed.

Fig. 12

Installing the Ceiling Mount

Bracket

NOTE: It is recommended that you

have all the wires connected before

permanently installing the ceiling mount

bracket onto the rooftop. See ‘Wiring

Diagram’ section on how to connect the

wires.

1. Push to remove the top cover of the

ceiling mount bracket. (Fig. 13)

Fig. 13

2. Follow the wiring guidelines below

to connect the cables from the

interior of the RV ceiling. See “Wiring

Diagram” section for detail. Fix the

wires with nylon cable tie. (Fig. 14)