Owner's Manual

6
Installation
4. Thread the cables of the LTE antenna
base through the opening. Put the
LTE antenna base over the opening
area. (Fig. 3)
NOTE: Make sure the center hole of
the LTE antenna is aligned with the
hole in the RV roof.
Rubber
Seal
Concentric
Fig. 3
5. Fix the LTE antenna base on the RV
roof using seven stainless steel self-
tapping screws and tighten using a
screwdriver. (Fig. 4)
***
NOTE: Do not overtighten as damage
to the base may occur, which will
void the warranty. A screw angle up
to 30 degrees is acceptable without
damaging the base.
Fig. 4
***
For FAN73B7C-BL3, six screws are
needed.
6. Insert the bottom collar of the TV
antenna wing into the center hole of
the LTE antenna base. (Fig. 5) Make
sure the rubber seal on top of the LTE
antenna base is in location.
Collar
Fig. 5
7. Fix the TV antenna wing in the LTE
antenna base using the two 4 x 12mm
square socket pan head tapping
screws provided with the product.
(Fig. 6)
Fig. 6
8. Apply a liberal amount of sealant
around the antenna base and
the screw holes to prevent water
leakage if necessary. Check with the
RV manufacturer for the standard
sealant for the vehicle. (Fig. 7)