Warranty

7
TTS1
3
WARNING: FAILURE TO SECURE UNIT TO WALL AS SHOWN MAY RESULT IN
SERIOUS INJURY
4
USE PART 6
TO TIGHTEN
ALL NEW
CONNECTIONS
IMPORTANT: TO INSURE PROPER AND SAFE INSTALLATION OF YOUR SHELF, YOU MUST:
1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL WHILE LINING EITHER THE RIGHT OR LEFT
FLANGE WITH A WALL STUD.
2. LIGHTLY MARK YOUR WALL USING A PENCIL THROUGH THE FLANGE SCREW HOLES (4 MARKS NEEDED
TOTAL).
3. REMOVE UNIT FROM WALL AND PREDRILL YOUR 4 MARKED SPOTS USING A 3/16" DRILL BIT.
4. REPLACE YOUR UNIT TO IT'S ORIGINAL DESIRED LOCATION AND SCREW IN PLACE USING THE ALLEN
WRENCH (PART 7) AND THE SCREWS (PART 8) PROVIDED. DO NOT OVER TORQUE!
MAKE SURE ALL AREAS ARE TIGHT AND HOLES ARE PREDRILLED BEFORE PROCEEDING!